SMART-D201

4Vdc digital control panel for swing doors.

  • Power supply for one or two 24Vdc swing door motors with direct current
  • Obstacle detection function with amperometric sensor with programmable threshold
  • Built-in 433.92 MHz radio receiver
  • Power for 24VDC electro lock
  • Power for 24VDC signalling lamp
  • Adjustable soft stop and operating speed
  • Imput for limit switches on opening and closing

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide of SMART-D201 control panel 952.14 KB
Other downloads
EC declaration of conformity SMART-D 389.46 KB

VIVO-D203

Universal 24Vdc digital control panel for swing, sliding and up-and-over doors.

  • Programming with 4 push buttons and 4 digit 7 segment display
  • Power output for 24Vdc electric lock
  • Management for start and pedestrian start via radio
  • Connector for traffic light management card
  • Power output for voltage free signalling lamp (for use in flashing lamps)
  • Total and partial operating cycle counter
  • Viewing input status via display and LED
  • Safety devices testing before every opening
  • Dead man function
  • Encoder input for 1 or 2 signals
  • Access code to restrict programming changes
  • On/Off switch control panel

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide VIVO-D203 1.21 MB
Other downloads
EC declaration of conformity VIVO-D203 389.33 KB

VIVO-D102

24Vdc digital control panel with encoder for up-and-over and sectional doors.

  • Programming with 4 push buttons and 4 digit 7 segment display
  • Obstacle detection function with amperometric sensor with programmable threshold
  • Connector for traffic light management card
  • Input for encoder
  • Input for emergency batteries (AVI04)
  • Soft start and stop for leaves in the opening and closing phase to prevent noisy opening and closing and rebounds
  • Adjustable soft stop and operating speed
  • Safety devices testing before every opening

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Technical datasheet of VIVO-D102 2.92 MB
Rapid guide of VIVO-D102 524.21 KB
Other downloads
EC Declaration of conformity VIVO-D102 389.29 KB

VIVO-D103

24Vdc control panel with limit switches for up-and-over and sectional doors.

  • Adjustment and programming via potentiometer and dip switch
  • Obstacle detection function with amperometric sensor with programmable threshold
  • Connector for IRRE2/IRRE2-250 radio receiver
  • Power for voltage free signalling lamp
  • Input for emergency batteries (12V)
  • Photocell shadow function on closing
  • Soft start and stop for leaves in the opening and closing phase to prevent noisy opening and closing and rebounds
  • On/Off switch control panel

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide VIVO-D103 498.88 KB
Other downloads
EC declaration of conformity VIVO-D103 389.29 KB

VIVO-M101,M201

12Vdc control panel with electric lock output for swing doors.

  • Adjustment and programming via potentiometer and dip switch
  • Power output for 24Vdc electric lock
  • Connector for IRRE2/IRRE2-250 or RSD radio receiver
  • Management for start and pedestrian start via radio
  • Output for garage light/courtesy light with timer
  • Soft start and stop for leaves in the opening and closing phase to prevent noisy opening and closing and rebounds
  • Management of 2 motors with independent brakes (VIVO-M202)
  • Dead man function

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide VIVO-M101 415.11 KB
Rapid guide VIVO-M201 468.01 KB
Other downloads
EC declaration of conformity VIVO-M101, M201, M202 389.34 KB

VIVO-M202

Analogue 230V control panel for swing doors.

  • Adjustment and programming via potentiometer and dip switch
  • Power output for 24Vdc electric lock
  • Connector for IRRE2/IRRE2-250 or RSD radio receiver
  • Management for start and pedestrian start via radio
  • Output for garage light/courtesy light with timer
  • Soft start and stop for leaves in the opening and closing phase to prevent noisy opening and closing and rebounds
  • Safety input on closing and opening
  • Management of 2 motors with independent brakes
  • Dead man function

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Annex VIVO-M202 441.83 KB
Other downloads
EC declaration of conformity VIVO-M202 389.34 KB

VIVO-M203

Control panel for swing, sliding and up-and-over doors with 230Va single-phase motors.

  • Programming with 4 push buttons and 4 digit 7 segment display
  • Power output for 12Vdc electric lock
  • Management for start and pedestrian start via radio
  • Connector for traffic light management card
  • Output for garage light/courtesy light with timer
  • Soft start and stop for leaves in the opening and closing phase to prevent noisy opening and closing and rebounds
  • Safety input on closing and opening
  • Photocell shadow function on closing (up-and-over doors)
  • Input for limit switches on opening and closing
  • Input for safety strips (mechanical or resistive 8k2)
  • Ready for E-LINK remote management system

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide of VIVO-M203 1.93 MB
Other downloads
EC declaration of conformity VIVO-M203 389.31 KB

VIVO-M204

Control panel for swing, sliding and up-and-over doors with 230Va single-phase motors.

  • Programming with 4 push buttons and 4 digit 7 segment display
  • Power output for 12Vdc electric lock
  • Management for start and pedestrian start via radio
  • Connector for traffic light management card
  • Output for garage light/courtesy light with timer
  • Soft start and stop for leaves in the opening and closing phase to prevent noisy opening and closing and rebounds
  • Safety input on closing and opening
  • Photocell shadow function on closing (up-and-over doors)
  • Input for limit switches on opening and closing
  • Input for safety strips (mechanical or resistive 8k2)
  • Ready for E-LINK remote management system

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Annex VIVO-M204 441.83 KB
Other downloads
EC declaration of conformity VIVO-M204 389.31 KB

EPEB, EPEB-PAL

Control panel for swing doors with analogue 230Vac single-phase motors and encoder.

  • Power supply for a swing door 230Vac single-phase motor
  • Power output for 12Vdc electric lock
  • Management for start via radio
  • Connector for traffic light management card
  • Output for 3sg garage light/courtesy light
  • Encoder input for 2 signals
  • Viewing input status via LED

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Manual A EPE motor 2.30 MB
Other downloads
EC declaration of conformity A-EPE 387.39 KB

AM600S

Analogue 230V control panel for sliding and up-and-over doors.

  • Adjustment and programming via potentiometer and dip switch
  • Connector for IRRE2/IRRE2-250 or RSD radio receiver (built-in fixed code uncoding)
  • Power output for 230V signalling lamp (for use in flashing lights)
  • Connector for traffic light management card
  • Encoder input for 1 signal
  • Safety input on closing and opening

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Manual of AM600S 2.90 MB
Other downloads
EC declaration of conformity AM600S 389.03 KB

AM606S

Analogue 230V control panel for sliding and up-and-over doors.

  • Adjustment and programming via potentiometer and dip switch
  • Connector for IRRE2/IRRE2-250 radio receiver (built-in fixed code uncoding)
  • Power output for 230V signalling lamp (for use in flashing lights)
  • Connector for traffic light management card
  • Encoder input for 1 signal
  • Safety input on closing and opening

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Manual AM606S 2.90 MB
Other downloads
EC declaration of conformity AM606S 389.03 KB

VIVO-M101PT

Control panel for sliding and up-and-over doors.

  • Adjustment and programming via potentiometer and dip switch
  • Power output for 12Vdc electric lock
  • Connector for IRRE2/IRRE2-250 radio receiver (built-in fixed code uncoding)
  • Power output for 230V signalling lamp (for use in flashing lights)
  • Connector for traffic light management card
  • Safety input on closing and opening
  • Dead man function
CLEVER01, 02

230V control panel for roller doors.

  • Adjustment and programming via potentiometer and dip switch
  • Connector for IRRE2/IRRE2-250 radio receiver (built-in fixed code uncoding) (CLEVER01)
  • Connector for IRRE2/IRRE2-250 radio receiver (CLEVER02)
  • Safety input on closing and opening (CLEVER02)
  • Automatic closing with programmable time
  • On/Off switch control panel (CLEVER01)
  • Dead man function CLEVER02)

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapide guide for control panel CLEVER01 297.71 KB
Manual for control panel CLEVER01 1.60 MB
Manual for control panel CLEVER02 2.31 MB
Other downloads
EC Declaration of conformity CLEVER01,02 389.05 KB

VIVO-I103, I203

230Vac digital control panel with inverter technology for swing, sliding and up-and-over doors.

  • Programming with 4 push buttons and 4 digit 7 segment display
  • Power output for 12Vdc electric lock
  • Management for start and pedestrian start via radio
  • Connector for traffic light management card
  • Total and partial operating cycle counter
  • Viewing input status via display
  • Safety devices testing before every opening
  • Dead man function
  • Encoder input for 1 or 2 signals
  • Access code to restrict programming changes
  • On/Off switch control panel

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide for control panel VIVO-I103,I203 2.38 MB
Other downloads
EC Declaration of conformity VIVO INVERTER 388.72 KB

VIVO-I204

230Vac digital control panel with inverter technology for swing, sliding and up-and-over doors.

  • Programming with 4 push buttons and 4 digit 7 segment display
  • Power output for 12Vdc electric lock
  • Management for start and pedestrian start via radio
  • Connector for traffic light management card
  • Total and partial operating cycle counter
  • Viewing input status via display
  • Safety input on closing and opening
  • Safety devices testing before every opening
  • Dead man function
  • Encoder input for 1 or 2 signals
  • Access code to restrict programming changes
  • On/Off switch control panel

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Annex VIVO-I204 441.83 KB
Other downloads
EC declaration of conformity VIVO-I204 388.72 KB

VIVO-T101

For sliding and swing doors.

  • Adjustment and programming via potentiometer and dip switch
  • Power output for 12Vdc electric lock
  • Connector for IRRE2/IRRE2-250 radio receiver (built-in fixed code uncoding)
  • Power output for 230V signalling lamp (for use in flashing lights)
  • Connector for traffic light management card
  • Safety input on closing and opening
  • Dead man function

MORE INFORMATION ABOUT THIS PRODUCT

Technical Manual
Rapid guide VIVO-T 911.62 KB
Other downloads
EC Declaration of conformity VIVO-T 388.67 KB

Storage Batteries
AOM01

24V auxiliary battery for door operators.

  • It serves as an emergency power supply in cases of power failure
  • It storages energy while the operator is electric powered
  • It provides 10 door activations in cases of power failure (with a full battery)
  • It comprises a plastic base, a metallic omega, two 1.3Ah baterries, and wired cables
ADN01

24V auxiliary battery with charger for door operators.

  • It serves as an emergency power supply in cases of power failure
  • It storages energy while the operator is electric powered
  • It provides 10 door activations in cases of power failure (with a full battery)
  • It comprises a case, a metallic support, a charger, two 1.3Ah batteries, and wired cables
AVI04

24V auxiliary battery with charger for door operators.

  • It serves as an emergency power supply in cases of power failure
  • It storages energy while the operator is electric powered
  • It provides 10 door activations in cases of power failure (with a full battery)
  • It comprises a metallic omega, a charger, two 2.2Ah batteries, and wired cables
ADO01

24V auxiliary battery with charger for door operators.

  • It serves as an emergency power supply in cases of power failure
  • It storages energy while the operator is electric powered
  • It provides 10 door activations in cases of power failure (with a full battery)
  • It comprises a charger, two 1.3Ah lead batteries, and wired cables

No olvide que para un correcto uso de su puerta y una larga vida del automatismo es necesario un mantenimiento.
Además de garantizar que tengan las seguridades en regla.

×